[2wheeldrift]

$100 Clams

2 New out of box, never mounted and with bolts

1 Used (no bolts)

Please PM if interested

 

[ragbagz]

PM sent

 

[vrodderD]

pm sent

 

[gsgrisso]

opcorn waiting to see if sold....

 

[2wheeldrift]

Still got em.

 

[jbone8069]

pm sent

 

[2wheeldrift]

I have a freind that has a set of stock wheels on his v-rod. I'm going to try to confirm if they will fit. Thanks for all of your replies and PM's. I hope to get it at some point this week.

Ride Safe,

 

[jon1zc]

Are you still offering? If so, do they fit an 02??

 

[AOW]

they sure are purdy!!

 

[Dylan454]

Would those bolt on to the reactor wheels? Are they for the fronts, or the rear, or does it not matter?

 

[Aaron871]

If whoever buy's these want's to sell their old rotors, I'm looking for a set (not warped) for my 06 "D".....

Sorry for the hijack.....

 

[VanislVrod]

is this all 3? 2 front 1 back rotor? if they fit a stock 03 wheel ill take em.

 

[Jaysvrsca]

02' non brembo

Are you still offering? If so, do they fit an 02??

Just fyi, the cfr rotors that he's selling will not fit your bike unless you have brembo brakes on your bike which will be an upgrade you would know about as they did not come stock for 02 or 03 for that matter. The brembo's are about 5mm wider and will rub the caliper housings of you stock non brembo's.

Hope this helps and BUMP for my boy 2wheeldrift!

 

[Jaysvrsca]

I have a freind that has a set of stock wheels on his v-rod. I'm going to try to confirm if they will fit. Thanks for all of your replies and PM's. I hope to get it at some point this week.

Ride Safe,

Hey homie, the rotors will bolt up to the rims they just wont fit on a NON BREMBO caliper as the housing will contact the rotors unless the CFR rotors are made to fit either. Are they smaller than the stock brembo's rotors?

The stock rotors on the non brembos are about 5mm smaller thus, no rubbing...

Shiny side up boys!

 

[jon1zc]

Thanks for the info Jayvrsca!

 

[bproulxvrod]

These will not fit stock wheels. These are meant for aftermarket wheels. Just look at the 5 hole bolt pattern in the center and then look at the stock rotors. The stock rotors have no center and just bolt on the inside edge (no full hole). Good luck with the sale but these were made for the CFR wheels or other aftermarket wheels with a larger disk to accomadate the V-rod. I can post pics later of a stock rotor and similar aftermarker rotor to show the difference.

 

[Jaysvrsca]

Thanks for the info Jayvrsca!

Anytime!

 

[2wheeldrift]

Gang, The verdict is in. No go on stock HD wheels. I get the bolt pattern and market them to buyers with an aftermarket set up that will work. Thanks for the reply's, requests, and PM's on this good deal!

 

[KEGGER1454]

thanks for checking it out first!