Harley Davidson V-Rod Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,943 Posts
Discussion Starter #1
I just bought one on ebay. My bike is an '06 R, topless with drilled baffles on stock mufflers. No map for this on the V&H website. I called for a) best approximation or b) definition for each mode so we could tune on dyno. Was told that they won't give mode sources and without specific application, I was basically SOL.
Does anybody have a source so I can write my own code or documented flow values for different muffler setups so I can match this up to an existing setup ? Other work arounds ? If not, I'm gonna be one unhappy camper & let everyone on the forum be on the alert for this product... :stilpoke:
 

·
Registered
Joined
·
1,943 Posts
Discussion Starter #2
V&H says this is similar to their Power Shots with topless. I loaded their recommended map, results were positive. The unit is not one you can fiddle with, as they won't release what parameters are covered by each of the 20 or some modes. However, ultra simple to install. I also had pully change, but et dropped from 13.1 to 12.3 and mph went from 106 to 110. Hope this is a help.
 
1 - 2 of 2 Posts
Top