Harley Davidson V-Rod Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,218 Posts
gasket alignment dowels/ grind the head off 2 allen bolts
trans holder I made out of a piece of flat poly and replicated factory tool
crank retainer really not needed
Crankcase aligning dowels/ used all thread and heat shrink over the entire section except for the small area need to thread in the case
Flywheel fixture HD-44358 is not a VRSC tool. It is for Air cooled Harleys
 

·
Registered
Joined
·
1,218 Posts
I lost out on the balance shaft tools by a day a while back. I also have a tool fetish. I did happen to find brand new OE crankshafts in the box on E-Bay for $328 OBO. I just grabbed one incase of a bearing failure down the road, and to have a spare backup for the 2 VRSC's I own. Gonna order the bearing sets to keep with it, once I have color code from the crank.
 
1 - 2 of 2 Posts
Top