[Droopytxn]

I went to replace the shaft and it was hard to pull out so i used pliers it came out fast. Well now i cant get the new one loned up to go all the way in. Ive pulled it out slowly turned one notch and tried allway around am i doing something wrong?

 

[zantegr]

I went to replace the shaft and it was hard to pull out so i used pliers it came out fast. Well now i cant get the new one loned up to go all the way in. Ive pulled it out slowly turned one notch and tried allway around am i doing something wrong?

Have a look at this video. He does the whole
Process. See if you did any of the steps differently. Also pay attention to how he keeps the spring in place.


Sent from my iPhone using Tapatalk

 

[rbabos]

I went to replace the shaft and it was hard to pull out so i used pliers it came out fast. Well now i cant get the new one loned up to go all the way in. Ive pulled it out slowly turned one notch and tried allway around am i doing something wrong?

What year of bike is it. Pre late 04s had problems where spring would detach .
Ron

 

[Droopytxn]

Its an o4 vrsca 08-03

 

[rbabos]

Its an o4 vrsca 08-03

That should have had the updated parts. More info here.

Shift Shaft

ok, I've read all the previous posts (at least I think I did), i've been able to remove the broken shaft and attempted to re-insert the new one, but can't make a clean line to the indent on the right side of the bike, something in gears wont allow a straight line. So if I remove oil pan, am I...

www.1130cc.com

Ron