Harley Davidson V-Rod Forum banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
11,390 Posts
The noise could be nothing more than the pads wearing unevenly. Check them out for wear front to back.

If the rotors warp bad enough you will feel a pulsing when applying the brakes. When the pulsing gets on your nreves then replace the rotors.

The thickness of the rotors should be stamped on the rotor itself along with the part number if the early H-D branded rotors
If you have Brembo brakes the thickness minimum is .18 inches
Edited 8/3/2010 to fix thickness minimum spec.
 

·
Premium Member
Joined
·
11,390 Posts
I'm replacing mine when they get down to 0.180" whether they need it or not.
Thanks. Post edited. .018 is a little too thin for you huh?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top