[shrabya]

Does anyone know how to remove the support bar from the rear weld pan? I would like to remove the black metal showing when I put the new rear fender. Has anyone done this or has any idea how to do it? I have attached the picture for reference.

Thank you.

 

[Tie_One_On]

cut it. I cut way more than that off

 

[drumminguy81]

Angle grinder, cut off disk.

Sent from my SM-N950U using Tapatalk

 

[freudie1]

Angle grinder, cut off disk.

Sent from my SM-N950U using Tapatalk

x3. I trimmed that mess a ton over the winter when cleaning up the rear fender section.

It has all kinds of "extra" areas for the side mounted plate, euro plate mount, side lights, etc.....that is IF you don't need/want any of that.

In other words, trim till you make it right for your setup. Have angle grinder will travel.