[gman57]

Went Topless now have CEL on

Okay I just went completely topless with some venting holes in bottom pan and put in the IAT relocation kit for 02s. I started it and noticed CEL light lit, then took it out for spin. After a whileI noticed the CEL was only half lit not the whole icon ? Ran up the rpms in a couple of gears and felt a little stumble in the acceleration then it cleared and I noticed the CEL was out... Few min later it came back on full. I just checked and cleared the P0113 code then restarted bike and it set P0113 again I did this twice more code came back. I checked IAT sensor and it was tight I unplugged sprayed elect cleaner blew it off and replaced it, rechecked and code came back .This is a new IAT sensor that came with the relocate kit, any ideas??????

 

[gman57]

I'll have try that plugging into the old sensor and see. If that doesn't work I'm gonna check the deutsch fitting I had to put on the old sensor lead where I had to cut it to extend it to reach. Possibly a pin didn't connect. Thanks Taxman

 

[gman57]

That was it bad connection at the deutsch connection a blob of solder wouldnt let one pin go in all the way and make a connection.Fixed that and then cleared the old code and started it CEL was out let it run a few minutes and all seems ok.Rain stopped so I'll have to take it for a spin....