Harley Davidson V-Rod Forum banner
1 - 2 of 50 Posts

· Registered
Joined
·
223 Posts
Val,
I had the same happen to me with the .. .020 map. Try this...
Switch the kill switch on then take the pc out of the cover and press the three buttons down and hold them down. Get someone to switch on the ignition then let the buttons go. Press and hold the low button until you see the led indicator go toward the lean mark for two flashes, then release the button and do the same with the midrange button. By adjusting these two buttons, you will lean out your mixture by 10% in the low and midrange. Let her sit for about 20 seconds then turn the ignition off. Put the pc back in the poach and tuck it back under the airbox. Your fuel economy will improve and should not be too rich anymore.
Cheers Derek
 

· Registered
Joined
·
223 Posts
Shawn, try downloading the 020 then manually lean it out in the mid and lower ranges by 10 %. Each time you press the button it will subtract or add at 5%. I run the same setup and get 114.9 hp and 84 tq. I have tried all the suggestions to try and copy my dyno sheet but am still having a hard time. Merry Xmas Derek
 
1 - 2 of 50 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top