Harley Davidson V-Rod Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
2016 prod, 5k miles

just finished a stage 1 install-

fitzgerald motorsports pipe
Dynojet target tune autotuner
Motohooligan hi-flo air intake

When the ride began, the fuel indicator began going wonky.
figured it was just a loose indicator. It showed me at 1/4 tank
then went to empty very quickly (I had plenty of gas in the tank).

Only rode for about 10 miles
then parked in garage. Turned bike off, everything seemed fine.

When I went to start the bike up about 10 minutes later, the fans
turned on and ran furiously for about 3-5 minutes and the red
oil indicator turned on and the bike won’t start (a safety feature I
suppose). I checked the oil, and there is plenty of oil in the pan.

Anyone got any ideas?
 

·
Registered
Joined
·
11 Posts
Discussion Starter · #3 ·
It appears the voltage is low according to my powervision. Must be the extreme heat here in Texas. Thanks for the help.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top