[BobT]

:helpme:
I picked up brand new,in the box, upper and lower beltguards from the Swap meet in Chicago. Both boxes were open and one had a locknut in it. But both had the directions :deal: missing :hmm: . Is it a straight forward exchange or are there any torque values I need to know ? Are there any tricks. I also have the 200 tire so I need to trim a little , Any success with rust retardant paint or something else work better ?
Thanks ahead of time for any help.
BobT

 

[BobT]

Thank you.
I will try the pre-fit before trim.
The new lock nut simply replaces the old.....Correct ?
BobT

 

[BobT]

Thanks again- The scoot is out in the out building(shop) all snug in its' bed.

BobT

 

[BobT]

It did not come with it. Anyone have the instruction sheet ,maybe look and see if individual part # 's are on the sheet(they are often on the sheet). Thanks alot Jav
Thanks to all of you.
BobT

 

[BobT]

Don't screw the next guy ......
I am not a cheapskate - I would just get the part from the stealer.
I do appreciate the offer.
But the person that buys it would be right back in my spot,heck they may be from the forum .
I sure hope they fit with the 200 tire----I have a brand spankin' new one on the back of my scoot!!!
BobT

 

[BobT]

Thank You all.
I am in no rush.
It is cold and snowy here .
I am thinking of putting in a furnace or some sort of heater in the shop , but we'll have to see after tax time........
Til then I wait impatiently for warmer weather.
Again, thanks for all the help.
BobT

 

[BobT]

Thanks everyone,
I am going to jot this down and get a new rubber grommet Part Number 67633-01
Thanks very ,very much.
BobT