Harley Davidson V-Rod Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter #1
I just finished reading through about 30 threads, but couldn't find the answer to my question. I recently took my 04 VRSCB in for it's 5000 mile service. While it was in the shop I had them installl my braided clutch line. The clutch works fine, but I notice that the lever seems to rattle. It never did this prior to the install. Is there anything I can do to tighten it up? Could there be air in the line that is keeping it a little loose? Don't understand how changing the line would have made a difference. I didn't have any problem with changing my brake line. Thanks.

Steve
 

·
Banned
Joined
·
4,397 Posts
my chrome lever rattles a bit at idle where my stocker didnt..
 

·
Registered
Joined
·
141 Posts
buckey,

i noticed the same thing after i took off levers to powdercoat. i even changed new snap ring on bottom, but still not as tight as before.
 

·
Registered
Joined
·
30 Posts
Discussion Starter #5
Pdiddy said:
buckey,

i noticed the same thing after i took off levers to powdercoat. i even changed new snap ring on bottom, but still not as tight as before.
Thanks Pdiddy, I was thinking about trying that too. Looks like it might just be a waste of time.
 
1 - 6 of 6 Posts
Top