Harley Davidson V-Rod Forum banner
1 - 1 of 1 Posts

· Wretched Excess.....
Joined
·
2,068 Posts
One word: ABUSIVE!! V-Man was right! Follow the instructions to the letter and watch the video. I must have spent close to an hour getting things to fit so I could get the side cover back on. I think the guy who installed the wiring harness on the bike knew I would be installing the PC and decided to make the harness a 1/4 inch shorter. The 2 service connectors that are loose must be pushed back in under the main harness just the way its shown in the instructions or you'll never get the 2 large connectors to fit under the side panel. I had to push pretty hard on the loose connectors and harnes to make room and I sure hope I didn't do any damage. Apparently there was no damage in the short term because the bike fired right up. Good luck, take your time and don't get pissed off. You'll make it work.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top