Joined
·
919 Posts
I have seen quite a number of posts and threads about sandblasting or sanding existing factory coatings from parts in preparation of polishing. I found this trick after I sanded and polished my first pulley. What a job! In preparation for the 240 swap, I purchased a black center pulley and didn't want to deal with all of the coating removal and then more sanding to get the part to a polishing point. The product I used is called Klean Stripper and is sold at Home Depot in the paint section. From start to finish was an hour and a half process with very little work involved. Mostly just waiting for the chemical to reactthen some scrapping with a plastic body filler tool ~Don't forget to use gloves! Below are some photos and I will post up more of the polishing process later. Good luck with your mods.
Tony
Tony
Attachments
-
66.1 KB Views: 32
-
2.6 MB Views: 50
-
2.2 MB Views: 31
-
2.8 MB Views: 41
-
2.2 MB Views: 38
-
2.5 MB Views: 36
-
1.5 MB Views: 34