Harley Davidson V-Rod Forum banner

1 - 6 of 6 Posts

·
George
Joined
·
5,411 Posts
Discussion Starter · #1 ·
I have! I just cut the OEM peg support added in 2" of 0.250" x 1.0" 316 Stainless. Gonna ride it a bit and if it does what I want, off to the chromer's
 

Attachments

·
Registered
Joined
·
1,980 Posts
One thing I want to point out. You may want to reweld the clevis so it is at a 45 degree angle from the ground. With it flat if you drag (and you will) the peg can't go up and it could cause problems...

-Keith
 

·
George
Joined
·
5,411 Posts
Discussion Starter · #4 ·
One thing I want to point out. You may want to reweld the clevis so it is at a 45 degree angle from the ground. With it flat if you drag (and you will) the peg can't go up and it could cause problems...

-Keith
It doesn't look it in the pic, but it is! The axis of the peg is EXACTLY the same as OEM. Somehow in the resizing through V-Bulletin, the photo was skewed. The pic is 90° off! Lemme try again.... Luxie sized:
 

·
George
Joined
·
5,411 Posts
Discussion Starter · #5 ·
1 - 6 of 6 Posts
Top