Harley Davidson V-Rod Forum banner

Status
Not open for further replies.
1 - 11 of 11 Posts

·
Registered
Joined
·
976 Posts
Discussion Starter #1

·
Registered
Joined
·
976 Posts
Discussion Starter #3
Weekly bump.

A couple of close offers .

A few interesting trades .

But still available .
 

·
Soul Stumpy
Joined
·
2,186 Posts
Can these be mounted so you have dual controls, or do you have to remove the fwds to mount these?
 

·
Premium Member
Joined
·
5,719 Posts
I have these on my '02 and there is a new bracket for the shifter input shaft. You have to remove the stock one and install the Rizoma one. You may be able to keep the H-D one on there and drill it out to mount the Rizoma linkage to it? Also the brake has it's own reservoir and master cylinder so you would have to install check valves in each line to ensure that the rear brakes work.
 

·
Registered
Joined
·
1,271 Posts
bp...do you have a pic on the bike and one of you with your foot on the pegs?
 

·
Registered
Joined
·
976 Posts
Discussion Starter #7

·
Hale=Yes
Joined
·
343 Posts
One question, Can the Rizoma rear set control kit be installed in the VRSCR Street Rod model?
Yes it can, I did it on my 06 "R". You must replace the left side rear motor mount with a non "R" mount and do a bit of maching on the right side lower brace/bracket, as it hits the lower forward fender mounting boss on the under side of the swingarm. It's not a vary big job really. PS IMHO If your looking for Rizoma parts, you should be talking to "Ohio Buckeye" here on the forum. Best of luck to you. Ed...
 
1 - 11 of 11 Posts
Status
Not open for further replies.
Top