Harley Davidson V-Rod Forum banner

Dyno

975 Views 7 Replies 5 Participants Last post by  VrodG
Well We ran her this morning max hp 114.7 max torque 79.5 The dyno guy said that this set up is a little rich -020....Should have bought the race tuner..... live and learn !
1 - 8 of 8 Posts
Pretty good numbers regardless of tuning product. I doubt you'd get more than 1 or 2 HP or .5 - 1 ft-lbs of torque even with the best tuner, regardless of tuning product.

Heck, I wouldn't even waste a lot of extra money doing dyno pulls your numbers are very respectable.

Now, quit worrying about the numbers and go for a ride :)
Not worred,,,,,,,I'M Happy it's close to everyone else with the same set up, but would be nice to clean it up a bit.
My constant lament (probably sounds more like a WHINE). Same setup.
Mark,
I thought you were a Racer?Never be happy always want more!:sinister:
You always need more.

Remember> 2nd place is the 1st loser.
I was just trying to be nice and what does it get me :slap2:

I didn't say I would be happy :sinister:
When I arrived early at the stealer, one of the tech stop and looked at my pipes rolled his eyes and went inside. Once we got the bike straped down the same tech came in and asked what I had been done to the pipes and bike. After explaining I went outside the dyno to watch them run the bike. They started talking and laughing about the third pull they pointed at the read out and the laughting STOPPED. I asked them why they where laughing and the one with the rolling eyes said that he has never seen a gutted pipe make HP.To make this story shorter by the end of our talk I was showing him how to make one of there bike's make more hp with the info I got here. I think I made a new friend and it goes to show that you can always learn.I want to thank everyone for all the help this is a first rate crew !!!!!!
See less See more
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top