Harley Davidson V-Rod Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
222 Posts
Discussion Starter · #1 ·
I just got the bike out of the shop, and these are the #'s
V-Mod pipes, SE CNC heads, SE cams, SERT, big filter topless, 58tbs

121.69
78.34

tech, says he could get maybe a couple of ponies above that, with a different
exhaust, but it runs good to me!!
 

·
Registered
Joined
·
2,746 Posts
Thats respectable, I would'nt race you. What are CNC heads?
 

·
Registered
Joined
·
222 Posts
Discussion Starter · #4 ·
CNC heads, are SE CNC ported heads, i bought them on E_Bay, they were the "stock" heads on the 05 SE, 1250 bikes, at least that is what i was told, they were very expensive then, but now you can get them on E-Bay very cheap, the installation is what kills you!!!
 

·
Registered
Joined
·
1,666 Posts
luisv-rod said:
CNC heads, are SE CNC ported heads, i bought them on E_Bay, they were the "stock" heads on the 05 SE, 1250 bikes, at least that is what i was told, they were very expensive then, but now you can get them on E-Bay very cheap, the installation is what kills you!!!
I am happy with your results because I have the same equipment but have put off the install because of the cost. I wasn't sure it was worth the money with out different cams and springs. I can see now that it is worth doing. Thanks.:notworth:
 

·
Premium Member
Joined
·
13,005 Posts
1 - 6 of 6 Posts
Top