Harley Davidson V-Rod Forum banner

:::2014 Abs wheels into 2008 Non-Abs Bike::: Help please

1029 Views 4 Replies 3 Participants Last post by  mike_w
Hello, I Need some help lol,

I’m looking to do 2014 Nightrod wheels into my 2008.

My bike is none abs, and the wheels I’m getting are abs.

What bearing part number do I need to change?

Change both sides? Do I need to change spacers as well?

Thanks you for the inputs
1 - 5 of 5 Posts
You really don't need to get new bearing. You can use the bearing that you have. Just check the spacers. If you really want to change the bearings, I would (and have on mine) go with ceramic bearings.
The bearing on the abs wheels are shorter from what I heard.

I think I supposed to switch to a non abs wheel bearing? I’m not sure what I supposed to do about the spaces tho
The bearing on the abs wheels are shorter from what I heard.

I think I supposed to switch to a non abs wheel bearing? I’m not sure what I supposed to do about the spaces tho
You can do one of 2 things. Change that bearing for the non ABS type (same as other side of wheel) and use the 2 std spacers off your bike or leave the bearing in and either add another spacer next to your std one to compensate for the difference or fabricate a one piece spacer to the correct size. You will then have different size spacers each side of the wheel so will have to be careful not to mix them up if you ever remove the wheel. Either method will work perfectly.
ABS bearing are 3mm wider than non-ABS bearing.
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top