Harley Davidson V-Rod Forum banner

2003 Fuel Assembly - Where to Buy?

10K views 37 replies 9 participants last post by  hedgehanter 
#1 ·
Hello,
I've got a 2003 VRSCA.
The fuel assembly is done for.
I would like to replace the entire assembly (fuel pump, filter, sending unit, hoses, etc).

The bike's dictated part number is 62109-01A.
Yet that part number is obsolete.

I got another part number (75123-01B) which is also obsolete.

What do you guys do when you want to change this out?
Is there a company that sells new units? Or rebuilds these units?
Or how do you go about it?

Thank you!
 
#37 ·
Hand Wheel Alloy wheel Finger Rim


If you mean the screen on the bottom of the pump good luck its attaches with a plastic tit. First time I was able to gently pry and wiggle it off. The second time I broke the tit off and hand to buy a new pump. I used a generic pump for Ford Mazda Mercury Lincoln E2044. I'm cheap and it came with strainer and the bottom of the pump is metal for $22.

Check and replace the flexible plastic fuel line mine had a pinhole in it where it rubbed on the rods.

Automotive tire Cylinder Gas Auto part Automotive wheel system


If your going to this much trouble probably should also replace the actual filter. I took apart rods and fuel gauge. Then push the metal filter up it is snug. I also noticed that when you start crossing part numbers some filters have the seam on the bottom avoid them. I used a MicroGard 33129 same number as WIX.


Back to gather except for screen.

Safety glove Motor vehicle Helmet Gas Engineering


The good part you just saved $400- $500 by not going to the stealer.
 

Attachments

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top