Harley Davidson V-Rod Forum banner
mod
1-11 of 11 Results
  1. Engine and Transmission
    What did you use to cut the tray? I've read people used a Dremel but do you use a small cut off wheel or a spiral cutting bit. How about an ossilating saw? Hand held fine hacksaw blade? Just trying to determine what technique works the best. Thanks.
  2. Custom Seat Support Installed

    Custom seat support installed, brake/run/signal lights relocated, Vertical LED lit plate frame installed.
  3. Custom Seat Support Installed

    Custom seat support installed, brake/run/signal lights relocated
  4. Custom Seat Support Installed

    Custom seat support installed, brake/run/signal lights relocated
  5. Filler Plate Welded In

    I made a template and cut a piece of .100 thick steel, and TIG welded it in.
  6. Post Cut

    Here is the piece after cutting out the fender support and smoothing it a bit.
  7. Cut Plan

    Here is where I cut it.
  8. Cut Plan

    Here is where I cut it.
  9. Fender Removed

    Heres my 07' DX with just the rear fender removed
1-11 of 11 Results
Top