Harley Davidson V-Rod Forum banner
1 - 9 of 9 Posts

willygonewrong

· Registered
Joined
·
33 Posts
Discussion starter · #1 ·
I know that people are mounting these above the throttle plates, but wont this just read boost. I thought that the map sensor is supposed to read vaccum to. Also could would someone be kind enough to send me the turbo/intercoolerbase map.

Thanks
Willy
 
PM sharkey....
as far as the turbo basemap, you choose the basemap based on your exhaust set up (2 to 2, 2 to 1), then in within the the Smartlink software window, you choose 'Configure', 'module settings' then nitrous or supercharger.
 
a 1 BAR MAP sensor reads just vacume a 2 BAR MAP sensor reads vacume and boost I think it is -14.5 to +14.5. send wardoc a PM for a copy of a map... here is his TMax thread - http://www.1130cc.com/forums/showthread.php?t=112399&highlight=tmax

I know that people are mounting these above the throttle plates, but wont this just read boost. I thought that the map sensor is supposed to read vaccum to. Also could would someone be kind enough to send me the turbo/intercoolerbase map.

Thanks
Willy
 
I know every turbo with the TM installed has to have the 2 BAR MAP sensor. I am not that schooled to answer your questions but there are quite a few trask owners here that have a TM installed.

Ya it is supposed vaccum and boost but being mounted above the throttle plates it will never read vacuum. so at idle it will not read as it is supposed to. right?
 
i am not saying that it is not going to work above the throttle bodies, i am just wondering if mounted were it will read vacuum and boost would it perform better because it is getting the correct info.
When I talked to (tec) @ Zippers the other day, he said the map sensor only reads boost and thats it.
 
1 - 9 of 9 Posts