Originally Posted by Jberes
I have an 07 night rod special and Iím trying to wire in my signal stabilizer but canít seem to get it working. Can any tell me where to posi tap the wires into? Or pictures. Iíve tried the male end of the signal harness right before the rear signals. Thanks..
Do you mean a turn signal "load equalizer"?
If so, it should have two inputs and a ground. One input should go to a V = violet wire and the other should go to a BN = brown wire that are fed by the TSM/TSSM/HFSM (turn signal/security module) pins 5 & 6 respectively.
These wires run from the TSM/TSSM/HFSM to the front and rear turn signals. On a 2007 VRSCDX the easiest place to find these is under the passenger seat at the TSM/TSSM/HFSM.
You say you tried at the male end of the rear turn signal harness. That should be a 6-place Multilock connector and the turn signal feeds are in positions 3 and 5 with grounds at positions 2, 4, and 6. The load equalizer inputs should go to positions 3 and 5 and the ground should go to 2, 4 or 6 (all are equivalent).