I was considering getting new throttle cables but haven't decided yet. Anyways, putting the bike back together now after a teardown to clean and check everything out. The cables seemed to fit and lay just fine before but upon re-installation, i don't know, just doesn't seem to look right. Its a 2011 Muscle. Cables go under bars, loop around into frame and go above the diagnostic plug/main fuse on the right side of battery, correct? Just seems stiff after routed next to battery then S curves over to the throttlebody and possible interfer with airbox? Just seems to bind a little, not snappy throttle. Anyways, anyone have a quick pic they can post or verify?