I have a 06 street rod that found the pavement when I was getting some go-juce. The clutch lever was the only casualty other then my pride. So the thing is HD wants an arm and half a leg for anything factory. As the clutch lever will be the main damaged item in any lay down of the bike. The aftermarket support for the V-Rods is slim to none in my area at least. So this lever is $65 individually or $135 for the set at the dealership. Rip off in my opinion. The thing I noticed is the 2014 and up Touring bikes from HD use a hydraulic clutch. The levers look the same but that's only using the eyeball measurement. Dose anyone know if they fit and if so why not use them? Over 100 different after market Touring levers and most sets are under $100. Sorry if I'm asking an old question. If they do fit and work then the aftermarket support for the levers at least will have gotten a lot bigger.