Originally Posted by csmith72
Okay, battery was definitely not holding a charge, swapped out with new one and problem still persists. Looking for a loaner ECM now to either verify it is the problem, or rule it out.
Okay, problem found.
broke down and paid the $8 for PDF versions of service manual, and electrical diagnostic guide. page 24 of EDG had me disconnecting components while ignition off, then turn on and see if the buss er cleared. 2nd step was disconnect ECM and see results.
Well I did not really disconnect ECM instead I removed the dynojet power commander from the circuit and tried that first..... bike has no errors and starts right up now.....
Now all i have to do is figure out if DPC lost its config or is truly bad, either way problem found.