Help the Noob!

has anyone reformed, cut out, melted and bent the hump in the back of the seat and the one on the pillion?

rumor to the noob has been theres electrical under there...is it affected by busting down the hump to as low as possible?
thanks,
Jim

Your TSSM is under there so there's not much room to bust a hump on it.

I busted out the hump for the gas cap to smooth the seat down when I modified the lower part of the pan.I have an inch of foam there now.Then I shaved a tad over 2 inches from the back foam,and the seat and my position is real comfortable now.I did this busting to a BadLander reduced reach seat.
You might want to buy a take-off seat and do some busting on it and save the original.




Elrod on the V-Rod