|
|
: Daytona Twin Tec
- VRFI Closed Loop fuel injection from Daytona Twin-Tec
- Daytona TwinTec VRFI-D hits the street
- VRFID Base Tunes (Files Only Please)
- VRFI Tuning ?
- daytona twin tec vrfid
- VRFI-D+ Rinehart 2-1 Q's
- VFRID Question
- Rinehart decel popping
- Is anyone running VRFID with V-Gauge?
- California EPa and VRFI d
- Decel popping gone
- First log..a few questions
- Rear trim table
- O2 sensors
- Twin Tuner Fuel Injection Controller
- Turbo Tuning
- Rear cylinder tuning.
- High IAC
- smoothrod is da man!
- twinscan 2+tuning aid for sert
- maxed BLM table
- twinscan 2
- Need Wego II Wide-band Install Help
- Wego Why?
- More Data Captain
- 110 octane
- VRFID timing
- Turbo AFR Data
- Twin Tec Switch
- Idle went erratic,IAC maybe??
- Idle speed
- Twinscan II+
- Temp and VRFID
- Starting Issue
- Wiring the WEGOIID + Twinscan II
- Ready to dance
- Source for weld-in O2 sensor bungs?
- Fans
- twinscan2+ wego pics?
- Should I buy a Twin Tech II+? Need advice...
- Basic questions about the TS II
- VRFID Cold start problem
- How much logging time?
- Logging time part II.
- Overcharged by Daytona
- Cross talk from the FILES ONLY Sticky.
- TScanPlus2 kit, do the 02 sensors screw into the old 02 sensor bungs on an 08?
- Help! Twinscan2 installation help needed.
- Wego 02 rear sensor is TIGHT against cylinder, any danger here? Pics.
- Timing
- Twinscan2, what values to set WEGO Parameters at?
- Autosaving software, anyone have good solution?
- Twinscan2 and PC3, any way to tune cylinders individually?
- Basic TwinScan tuning questions.
- Base Map Help 2005 Screamin Eagle
- OK to have cells maxed out, but twinscan still says they need richening?
- Welding of 'bungs' into header pipes
- What do I need to go Twin Scan II+?
- Decel pops and how I finally got rid of mine.
- Twinscan autosave, ride for hours non-stop
- Part# for wegoIIID sensor
- Tuning for different AFR's???
- WTB: VRFI View software & Cable
- need TSII data help
- Twin Scan II, won't read my ECM!
- Need some expert tuning help!!
- 1250 help
- Am I the only one complaining to Daytona over the 12 minute buffer?
- Tuning done
- Tuning Daytona Twin tec
- Proof the TSII+ works
- TSII+, OK I'm an idiot.
- Anyone collect data with a PDA?
- cold starts
- VRFID/WEGO II Installed
- TSII Software Update
- Who's Still Running the VRFID?
- Underestimating vs. Overestimating HP in VRFID
- New to the VFRID
- Your guess is as good as mine
- Front Cylinder O2 Sensor Bad
- Engine "woofs", sometimes stalls
- New TSII software version
- front cylinder runs
- dry nitrous
- NEW VRFI III released
- Knock sensor VRFID Gen 3 ?
- VRFI-D with N20
- VRFI3 Software Out
- vrfid cold start-HELP
- invalid firmware
- Speed Calc. ?
- Thundermax and Harley security
- Can TwinScanII log timing retard?
- Vfrid iii
- O2 Sensor install?
- Need help. Where to start with VRFI D...
- Does the vrfi work without the wego
- Injector pulse width in Twinscan
- VRFI III Firmware
- good price?
- Any drawbacks to this? Anybody still using it?
- Bub 7 Base map?
- VRFI Gen 3 isn't auto tuning
- anyone running the VRFI3 with 3 bar map setup?
- looking for a better tuner for my DX
- TWIN TUNER 2 Base settings
- VRFI Learning Curve?
- Considering VRFI Gen 3, need input
| |
|
vBulletin® Copyright ©2000-2012, Jelsoft Enterprises Ltd.